1. This site uses cookies. By continuing to use this site, you are agreeing to our use of cookies. Learn More.

HyperCon Brightness much too high / no more colors

Discussion in 'Software Support' started by MikeOO, 14 October 2017.

  1. MikeOO

    MikeOO New Member

    Messages:
    19
    Hardware:
    RPi1/Zero
    2 (wonderful...) days my setup was working perfect. Thanks Devs!

    Now i got a strange problem: the brightness seems to be much to high. That results in only white light, but no more colors.
    When i reduce the luminance in Hypercon to 1 (sat remains 2), the colors are normal again. With 2 / 2, only white light.
    The same goes for the color SSH-wheel in Hypercon: if i reduce the brightness there (while keeping 2/2 in Page 1), there is color again. With the normal setting in the wheel, i get only white light, no more color.
    Of course meanwhile i created a json with lum1/sat2. But that has no effect: i have to manually reduce lum to 1 again in Hypercon manually to get colors,

    How to fix this? Already updated Hyperion without success.
     
  2. MikeOO

    MikeOO New Member

    Messages:
    19
    Hardware:
    RPi1/Zero
    Any Help in this case? The problem still occures from time to time. After a night of shutdown its always gone. A reboot is not enough, a short shutdown too. It has to be some hours.
     
  3. Jay9e

    Jay9e New Member

    Messages:
    1
    Hardware:
    RPi3
    Did you ever figure out how to properly fix this? I'm having the exact same problem and I tried everything, even resoldered my led strips and it still doesn't work