1. This site uses cookies. By continuing to use this site, you are agreeing to our use of cookies. Learn More.

RPi + OSMC HELP!!! 276 LEDS not responding

Discussion in 'Hardware Support' started by DiceBanga, 12 December 2018.

  1. DiceBanga

    DiceBanga New Member

    Messages:
    29
    Hardware:
    RPi3, 32/64bit, +Arduino
    AAAAAND now it stopped altogether. No startup config, NOTHING. I don't know if this PSU could be an issue??
     
  2. matthew henry

    matthew henry New Member

    Messages:
    12
    Hardware:
    RPi3
    I think it very well couldbe

    how do you have your LED's wired in regards to power? DO they have power going in from both sides?

    also

    276 WS2812B LEDS > 5V 10A PSU + DATA 10

    60mA * 276= 16,560mA @ Max brightness

    16.56 amps would be the MINIMUM for max brightness.
     
  3. DiceBanga

    DiceBanga New Member

    Messages:
    29
    Hardware:
    RPi3, 32/64bit, +Arduino
    Sorry it took me so long to respond. Was busy during holidays. To answer your question, no they were just powered from the bottom right corner. And I actually just realized that I wasn't giving it enough power.

    I've since purchased a 5V 20A PSU and wired it up, but I'm getting no response now. Could my LEDs be dead; or the nano? The Ard. nano still lighting up, but it doesn't seem to be sending any signals to the LEDs. Any help would be appreciated.