1. This site uses cookies. By continuing to use this site, you are agreeing to our use of cookies. Learn More.

Hyperion doesn’t start automatically

Discussion in 'Hyperion General' started by Ryan, 6 October 2018.

  1. Ryan

    Ryan New Member

    Messages:
    13
    Hardware:
    RPi1/Zero, RPi3
    I installed hyperion on raspbian lite on my Pi Zero W. The installation and configuration was succesfull, however, hyperion doesn’t start automatically when I start my Pi. Does anyone know how to solve this issue? Thanks!
     
  2. nach00

    nach00 New Member

    Messages:
    18
    Hardware:
    RPi1/Zero, RPi2, RPi3, +Arduino, +PhilipsHue
    Are you saying that you have to start Hyperion through Hypercon program?
    Have you tried reinstalling? SPI and SSH must be enabled. What OS did you install?
    The 0W and 1B take much longer to load than the 2 and 3.
     
  3. Ryan

    Ryan New Member

    Messages:
    13
    Hardware:
    RPi1/Zero, RPi3
    Yes, i have to stop and start hyperion everytime using the hypercon tool or ssh. Everything was installed correctly. I already found a solution. There seems to be a problem with Raspbian Stretch Lite. When using Raspbian Jessie Lite everything works fine.
     
  4. Mitch7391

    Mitch7391 New Member

    Messages:
    1
    Hardware:
    RPi3
    This happens to me every time my raspberry pi 3b reboots, I have to get on my laptop and connect with hypercon, stop and then start and it’s good. Any advice on how to fix this without having to reinstall my whole Pi again? I’v got a dual boot of Libreelec and Retropie on it.