1. This site uses cookies. By continuing to use this site, you are agreeing to our use of cookies. Learn More.

RPi + LibreELEC Software help ambilight

Discussion in 'Software Support' started by Beeradkorn, 12 April 2019.

  1. Beeradkorn

    Beeradkorn New Member

    Messages:
    2
    Hardware:
    RPi3, +Arduino
    ive been trying to build ambilight kit for tv, I’m a little computer literate but no pro by any means. I’m running rpi3 b+, LibreELEC 9.0.1 with Hyperion installed, also connect to arduino. Video grabber 007 chip set, lights are ws2812b. I’ve sent config file for hyperion via HyperCon thru computer. When i boot system up it starts fine and lights briefly light up. So where I’m stuck is When I go to Hyperion, neither run or configure buttons are highlight so I can’t start it. Any help would be greatly appreciated. Thanks
     
  2. harun

    harun Member

    Messages:
    61
    Hardware:
    RPi3
    Do you have installed fastled on the arduino?
     
  3. Beeradkorn

    Beeradkorn New Member

    Messages:
    2
    Hardware:
    RPi3, +Arduino
    No I don’t, I have a Hyperion sketch loaded on it, something I saw on YouTube. I will try that. Thanks