1. This site uses cookies. By continuing to use this site, you are agreeing to our use of cookies. Learn More.

[Updated 10/08/2018] [v2.6] Multiple Displays + Servers, 4K UHD (DirectX 11) Windows Screen Grabber

Discussion in 'Archive' started by Sabaat Ahmad, 22 September 2017.

?

DirectX 11 screen capture performs better than DirectX 9?

  1. Yes

    94.1%
  2. No

    5.9%
Thread Status:
Not open for further replies.
  1. Sabaat Ahmad

    Sabaat Ahmad Member

    Messages:
    54
    Hardware:
    RPi3, +Arduino
    You basically need to enable proto port on Hyperion and point the software to it. Also give priority to proto over others in Hyperion.
     
  2. gazm2k5

    gazm2k5 New Member

    Messages:
    7
    Hardware:
    RPi1/Zero
    Thanks, seems to be working now. I get a notification in Window saying it's successfully connected.
    Only trouble is now Hyperion on the RPi seems to crash when using the Windows configuration tool to manually change a colour. And it doesn't seem to change colours with the Windows Screen Grabber either. :thumbsdown: I've created a separate thread about that though.
     
  3. pho08

    pho08 Member

    Messages:
    56
    thanks for the great work! i use this on a daily basis and it works very reliably/stable!

    only concern for me is the performance takes quite a hit in some games specifically. Most of the time it is around 10% GPU but for some games i noticed rather 20% extra GPU load.

    so i was wondering are you still planning any updates for the Application in the future Sabaat? Or is this project finished
     
  4. kuma

    kuma New Member

    Messages:
    4
    Hardware:
    RPi2, RPi3, +Arduino, +PhilipsHue
    Hey,

    I really love your software and it works perfectly with the old hyperion. But I cannot get it to run with hyperion.ng. I used the same settings as for the old hyperion but my leds dont get any signal. I tested it with alpha3 - alpha6 and the problem persists. When I change back to the old hyperion everythings runs again. I havent tested the other alphas so I cannot say when the problem occured. Has anything changed regarding the proto server or how hyperion.ng handles the input data?
     
  5. Sousanator

    Sousanator New Member

    Messages:
    8
    Hardware:
    RPi3
    What are your settings? I think I remember it didn't work for me until I set the priority to 100
     
    • Like Like x 1
  6. kuma

    kuma New Member

    Messages:
    4
    Hardware:
    RPi2, RPi3, +Arduino, +PhilipsHue
    Thanks for your reply and the great tipp. Changing the priority from 10 to 100 solved the problem and now the software and hyperion ng is runnung like a charm
     
Thread Status:
Not open for further replies.